SCAlLX-LVDS-2-MIPI
SCAILX-LVDS-2-MIPI (rev. 4.0)
The LVDS-2-MIPI interface board is used to interface between the SCAiLX SOM and Videology LVDS Zoom-block cameras, as well as 2 MP LVDS Zoom blocks from SONY and TAMRON. The video resolution of the MIPI ports on the SCAILX-SOM-AI board is max. 1920x1080p at 60 fps.
The SCAILX-LVDS-2-MIPI boards converts the single or double channel LVDS signals coming from the zoom block camera into a 4-lane MIPI signal. The MIPI signal is fed into the SCAILX-SOM-AI module through the MIPI CSI port connector (J1), with additional power and I2C bus and camera control signals (GPIO).
SCAILX-LVDS-2-MIPI | Type | SCAILX-SOM-AI board |
|---|---|---|
J1 | MIPI CSI port | CSI2 port |
J2 | KEL zoom block interface | - |
Dimensions
front side
back side
side view
Connection
The SCAILX-LVDS-2-MIPI board is placed on the back of the SCAILX-SOM-AI board, where the MIPI-OUT connector of the SCAILX-LVDS-2-MIPI is connected to the CSI1-IN connector on the SCAILX-SOM-AI board (as depicted below). The zoom block camera connects to the SCAILX-LVDS-2-MIPI board via a KEL cable (pin 1 to pin 30 configuration). The LVDS zoom block camera is connected to connector J2 (KEL).
KEL connector pinout
Compatibility: LVDS camera with single and/or double LVDS based on THC63LVD827 or equivalent.
Programming and setup
The FPGA configuration is automatically loaded to the SCAILX-LVDS-2-MIPI board at startup of the SCAILX-SOM-AI on detection of the presence of the SCAILX-LVDS-2-MIPI board. The MIPI video port is automatically initiated by an associated driver for the SCAILX-LVDS-2-MIPI board.
Datasheet
Step 3D model